Configuring PIM Options To configure PIM options, perform this procedure: Implementing IPv6 Multicast Configuring PIM Options Command or Action Purpose Step 5 show ipv6 pim interface [state-on] [state-off] [type-number] Example: Device# show ipv6 pim interface Displays information about interfaces configured for PIM. Step 6 show ipv6 pim group-map [group-name | group-address] | [group-range | group-mask] [info-source {bsr | default | embedded-rp | static}] Example: Device# show ipv6 pim group-map Displays an IPv6 multicast group mapping table. Step 7 show ipv6 pim neighbor [detail] [interface-type interface-number | count] Example:
Device# show ipv6 pim neighbor Displays the PIM neighbors discovered by the Cisco IOS software. Step 8 show ipv6 pim range-list [config] [rp-address | rp-name] Example: Device# show ipv6 pim range-list Displays information about IPv6 multicast range lists. Step 9 show ipv6 pim tunnel [interface-type interface-number] Example: Device# show ipv6 pim tunnel Displays information about the PIM register encapsulation and de-encapsulation tunnels on an interface. Step 10 debug ipv6 pim [group-name | group-address | interface interface-type | bsr | group | mvpn | neighbor] Example: Device# debug ipv6 pim Enables debugging on PIM protocol activity.
Step 11 copy running-config startup-config (Optional) Save your entries in the configuration file. Implementing IPv6 Multicast 16