Procedure Implementing IPv6 Multicast Enabling IPV6 PIM Stub Routing Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 ipv6 multicast pim-passive-enable Example: Device(config-if)# ipv6 multicast pim-passive-enable Enables IPv6 Multicast PIM routing on the switch. Step 4 interface interface-id Example: Device(config)# interface gigabitethernet 9/0/6 Specifies the interface on which you want to enable PIM stub routing, and enters interface configuration mode. The specified interface must be one of the following:
• A routed port—A physical port that has been configured as a Layer 3 port by entering the no switchport interface configuration command. You will also need to enable IP PIM sparse mode on the interface, and join the interface as a statically connected member to an MLD static group. • An SVI—A VLAN interface created by using the interface vlan vlan-id global configuration command. You will also need to enable IP PIM sparse mode on the VLAN, join the VLAN as a statically connected member to an MLD static group, and then enable MLD snooping on the VLAN, the MLD static group, and physical interface. These interfaces must have IPv6 addresses assigned to them. Implementing IPv6 Multicast 22