Configuring Static Mroutes Static multicast routes (mroutes) in IPv6 can be implemented as an extension of IPv6 static routes. You can configure your switch to use a static route for unicast routing only, to use a static multicast route for multicast RPF selection only, or to use a static route for both unicast routing and multicast RPF selection. To configure static mroutes, perform this procedure: Implementing IPv6 Multicast Configuring Static Mroutes Command or Action Purpose Device> enable Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 ipv6 mld ssm-map enable Example:
Device(config)# ipv6 mld ssm-map enable Enables the SSM mapping feature for groups in the configured SSM range. Step 4 no ipv6 mld ssm-map query dns Example: Device(config)# no ipv6 mld ssm-map query dns Disables DNS-based SSM mapping. Step 5 ipv6 mld ssm-map static access-list source-address Example: Device(config-if)# ipv6 mld ssm-map static SSM MAP ACL 2 2001:DB8:1::1 _ _ _ Configures static SSM mappings. Step 6 exit Example: Device(config-if)# exit Exits global configuration mode, and returns the switch to privileged EXEC mode. Step 7 show ipv6 mld ssm-map [source-address] Example: Device(config-if)# show ipv6 mld ssm-map Displays SSM mapping information.
Step 8 copy running-config startup-config (Optional) Save your entries in the configuration file. Implementing IPv6 Multicast 28