en Rinse aid system Additional power consump- tion in kWh 0.05 2. Add rinse aid up to the max mark. The consumption values specified are laboratory measurements determ- ined in accordance with the currently applicable standard using the Eco 50° programme and with the factory value of the water hardness set to 16 - 20 °E. max 12 Rinse aid system 3. If rinse aid spills out, remove it 12.1 Rinse aid from the tub. Spilled rinse aid can cause ex- cessive frothing during the wash cycle. 4. Close the lid of the dispenser for For optimum drying results, use rinse aid. Only use rinse aid for domestic dish- washers. rinse aid. a The lid clicks into position.
Adding rinse aid If the rinse aid refill indicator lights up, top up with rinse aid. Only use rinse aid for domestic dishwashers. 1. Press the catch on the lid of the 12.2 Setting the amount of rinse aid If there are streaks or water marks on tableware, change the amount of rinse aid. 1. Press . 2. To open the basic settings, press dispenser for rinse aid and lift . for 3 seconds. a The display shows Hxx. a The display shows . 3. Press repeatedly until the display shows the value r05 set at the factory. 4. Press repeatedly until the right amount of rinse aid has been set. – A low setting adds less rinse aid during the wash cycle and re- duces streaking on tableware.
– A higher setting adds more rinse aid during the wash cycle, reduces water marks and im- proves the drying result. 26 2 1