en Rinse aid system Ў The water hardness is 0 - 8 °E. You do not need to use special salt. 2. Add rinse aid up to the max mark. 1. Press . 2. To open the basic settings, press for 3 seconds. a The display shows Hxx. a The display shows . 3. Press repeatedly until the dis- play shows H00. 4. To save the settings, press max for 3 seconds. a The water softening system is 3. If rinse aid spills out, remove it switched off and the salt refill indic- ator is deactivated. from the tub. Spilled rinse aid can cause ex- cessive frothing during the wash cycle. 4. Close the lid of the dispenser for 12 Rinse aid system rinse aid. a The lid clicks into position.
12.1 Rinse aid For optimum drying results, use rinse aid. Only use rinse aid for domestic dish- washers. 12.2 Setting the amount of rinse aid If there are streaks or water marks on tableware, change the amount of rinse aid. 1. Press . 2. To open the basic settings, press Adding rinse aid If the rinse aid refill indicator lights up, top up with rinse aid. Only use rinse aid for domestic dishwashers. 1. Press the catch on the lid of the for 3 seconds. a The display shows Hxx. a The display shows . 3. repeatedly until the dis- play shows the value r04 set at the factory. 4. Press repeatedly until the right amount of rinse aid has been set.
– A low setting adds less rinse aid dispenser for rinse aid and lift . during the wash cycle and re- duces streaking on tableware. – A higher setting adds more rinse aid during the wash cycle, reduces water marks and im- proves the drying result. 26 2 1