Delta ISPSoft — 20.4.6 Download Ether Link Configuration

Chapter 20 Network Configuration and Data Exchange After the users use one of the methods described above, the Starting Mode Setup window will appear. The page displayed in the window varies with the information selected. The users can click the tabs in the window. Select a mode in the Start Mode drop-down list box. If SM Flag is selected, the users can select an initial state in the Download State drop-down list box. After an initial state is selected, the users can click OK . 20.4.6 Download Ether Link Configuration After the parameters related to an Ether Link are set, users have to download the parameters to PLCs. The PLCs can perform data exchange after the parameters are downloaded.

 Single node Only the data demanding setting related to the PLC selected, the start mode of the PLC selected, and the start modes of the modules connected to the PLC are downloaded. Before downloading the related parameters, please make sure the system is well-connected to hosts or modules.  Method 1 Select a data demanding node to download parameters, click on the toolbar. The users can also download the related parameters by selecting a data demanding node, clicking the PLC menu, pointing to Transfer , and clicking Download (Single PLC) . 20-69