Chapter 2 Starting and Setting ISPSoft D. AH series PLC (RS232/422/485) The COM port for AH series PLC host is a standard type, therefore, please use RS232 communication of RX and TX lines or an adapter that has jumper function to proceed the connection with a computer. Please select RS232/422/485 for COMMGR driver type. Note: (a) Before connecting, please confirm that the setups in COMMGR drive concerning RS232 parameters is the same as in PLC hosts. (b) The COM interface of AH series provides many modes including RS232/RS485/RS422. Before connecting, please confirm that current desired mode is correct. (Please refer to follow-up comments.) E.
AH/AS series PLC, DVPxxMC, AS5xx and DVP-SE (Ethernet) The AHCPU5xx-EN, AHxxEMC, AS series, DVPxxMC, AS5xx and DVP-SE series PLC hosts contain built-in RJ-45 port (Ethernet) and can connect with a PC through Ethernet. A PC can also connect with a PLC host to the same domain through the hub or uses direct network cable for connection. Please choose Ethernet for COMMGR driver type. Note: (a) Before connecting, please check the structure of the internet is properly functioning. (b) Check the accuracy of the Ethernet parameter in host CPU. Please refer to follow-up comments 2-61