Chapter 23 Wizard Tool 23.1.5 Control Mode – Single axis point-to-point motion Description regarding single axis point-to-point mode setting. No. : The number is generated by the system and the maximum No. is 200. Control Mode: A motion type. Choose Single-axis point-to-point motion . Axis No.: An axis controlled by the data. ABS/REL mode: Relative Mode increases or decreases based on the current coordinates. Absolute Mode increases or decreases based on the absolute coordinates as target position. Relative mode (Symbol/Address) increases or decreases based on the current coordinate address, symbol or address are allowed.
Absolute mode (Symbol/Address) increases or decreases based on the absolute coordinates as target position, symbol or address are allowed. Target position: Target coordinate. For ABS/REL mode , the options include symbol/address. Target speed : Maximum speed of the target. Bias speed: The start and ending speed. Acceleration time: The time to reach target speed. Deceleration time: The time to reach stop. Completion action: Go to next segment to complete the data and continue to the next. Completion refers to an end once data is complete. Completion flag (I/M) : When the data execution is complete, set the register to ON.
The register range is set as M0~M8191 or I510~I519 only when Completion action is set to Completion . No. of next segment: Continue with the next data number, not limited to the same assigned axis number. But, take note that the same axis number cannot output more than 2 numbers from the table or output position command at the same time. When Completion action is set to Completion , the number is automatically continued to the next segment 23-9