Appendix A USB Connection the Communication Port section, select the number of times the sending of a command is retried if a connection error occurs in the Time of Auto-retry box, and select an interval of retrying the sending of a command in the Time Interval of Auto-retry box. Click OK . If the device name corresponding to the PLC connected does not appear in the COM Port drop-down list box, users have to check whether the device name of the PLC connected is under Ports (COM&LPT) .
If the device name of the PLC connected is not under Ports (COM&LPT) , the users have to check whether the PLC is correctly connected to the computer with the USB cable, and check whether the driver for the PLC is corrected installed on the computer. After the users make the checks, they have to close the Driver Properties window, and open the window again. (6) Click the driver created in the COMMGR window, and then click Start . *. Please refer to section 2.4 for more information about subsequent tests and the operation of COMMFR. A-19