21.3.1 Introduction of CARD Utility ...................................................... 21-6 21.3.2 Backup .................................................................................. 21-8 21.3.3 Restoration ............................................................................ 21-13 21.3.4 Command-line Instruction Execution .........................................21-17 Chapter 22 G-Code Editor and E-CAM Editor 22.1 G-Code Editor (Not Supported by the Current ISPSoft Version) ... 22-2 22.1.1 About G-Code ......................................................................... 22-2 22.1.2 G-Code Command Structure .....................................................
22-2 22.1.3 Using G-Code Editor ................................................................ 22-4 22.2 E-CAM Editor ................................................................................ 22-8 22.2.1 About E-CAM (Electronic CAM) .................................................. 22-8 22.2.2 The Significance and Description of E-CAM .................................. 22-8 22.2.3 Using E-CAM Editor .................................................................. 22-9 Chapter 23 Wizard Tool 23.1 Position Planning Table ................................................................ 23-2 23.1.1 About the Position Planning Table ...............................................
23-2 23.1.2 Setting the Position Planning Table ............................................. 23-2 23.1.3 Positioning Table Simulation ...................................................... 23-6 23.1.4 Upload and Download Position Planning Table .............................. 23-8 23.1.5 Control Mode – Single axis point-to-point motion ......................... 23-9 23.1.6 Control Mode – Single axis multi-segment .................................. 23-10 23.1.7 Control Mode - 2-axis linear interpolation motion ........................ 23-11 23.1.8 Control Mode - 2-axis Arc Interpolation Motion ...........................
23-13 23.2 Data Tracer ................................................................................ 23-14 23.2.1 About Data Tracer ................................................................... 23-14 23.2.2 Opening the Data Tracer Window .............................................. 23-14 23.2.3 Sample Parameter Settings ...................................................... 23-17 23.2.4 Sampling Modes ..................................................................... 23-20 23.2.5 Measurement ......................................................................... 23-22 xvi