Chapter 3 PLC System Configuration & Settings X0.8~X0.15 will match IO interrupt 1~ IO interrupt 8 separately. Please refer to chapter 5 for more information. Tab IO Input Filter is for users to setup IO input filter to reject unwanted signals. X Input Single Filter Time Users can set up the response time for pulse input, the setting range is 0~1000, unit is ms. Any response time below the set-up value will be filtered. X Input Single Hardware Frequency Filter Time Users can set up the value to be lower than the time of X input Duty On, the setting range is 1~50000000, unit is 0.1us.
Base on the time (t) and frequency filter equation (f) * = (Hz), if the frequency input signal is higher than the (f) * value, the input signal will be filtered. (For more information on the time of X input Duty On, please refer to AH Motion Controller operation manual.) *. About IO Input Filter, please refer to AH Motion Controller operation manual for more information. 3-201