ISPSoft User Manual If users want to set a data register, they can click in the Address cell for a parameter, and type a data register address which will be used in the Address window. Please note that a data register address which has been assigned to the module cannot be used again. If users want to delete the data register address in the Address cell for a parameter, they can open the Address window in the same way, and delete the data register address in the window. If the color of the Address cell for a parameter is grayed out, users can not set a data register for the parameter. In the example below, the values of these parameters are binary values.
The states of certain bits in the data register set in the Address cell for the first parameter correspond to these parameters. Please refer to the documents for the modules for more information about the relation between parameters and the states of the bits in data registers. Monitor After users click Monitor Table on the Option menu in HWCONFIG, they can access a module through the data registers in the Monitor Table window. As a result, if a data register is set for a parameter in a module, and the checkbox in the Monitor cell for the parameter is selected, the data register specified will be displayed in the Monitor Table window after the Monitor Table window is opened.
The checkbox in the Monitor cell for a parameter to which no data register is assigned cannot be selected. In the example below, D3000~D3003 are assigned to the parameters, but only D3000 and D3001 are monitored. As a result, only D3000 and D3001 will be displayed in the Monitor Table window after the Monitor Table window is opened. Please refer to section 3.8.6 for more information about Monitor Table in HWCONFIG. 3-234