Chapter 4 Quick Start (3) After the POU is added, a program editing window will appear in the main working area. Local symbol table Program editing area After the program editing window is opened, the corresponding toolbar will appear in the window. The functions are described below. *. Please refer to section 4.5.3 for more information about typing an instruction.
4-11 Icon Keyboard shortcut Function None Switch to the Address mode Shift+Ctrl+C Displaying/Hiding the comments on the networks None Displaying/Hiding the commands on the devices Shift+Ctrl+B Adding a bookmark to the network selected or deleting a bookmark from the network selected Shift+Ctrl+P Going to the previous bookmarked position Shift+Ctrl+N Going to the next bookmarked position Ctrl+I Putting a network above the network selected Shift+Ctrl+I Putting a network under the network selected ESC Selection Typing an instruction Inserting a contact Typing an instruction Inserting a coil Typing an instruction Inserting a comparison contact Typing an instruction Selecting a type of comparison contact Typing an instruction Inserting a block logic instruction (NP/PN/INV/FB NP/FB PN) _ _ Typing an instruction Selecting a type of block logic instruction (NP/PN/INV/FB NP/FB PN) _ _ Shift+Ctrl+U Inserting an instruction or a function block