Chapter 4 Quick Start When adding devices, press [Insert] on the keyboard to choose Insert or Replace mode. Use [Insert] on the keyboard to input LD M5 on M1 position and M1 is replaced by M5 (see below). 4.5.4 Basic Editing - Selection of a Network and Operation When selecting in the ladder diagram, users can press [Esc] on the keyboard, or click from the toolbar. After the mouse cursor appears in select mode, click the selected item. Basic operating steps are shown below.
Select the entire network Select an input Select the section Select the output coil Select the block If users want to select a group of devices, they can click a device, and drag it to draw a frame round the group of devices. The users can also select the group of devices by clicking the first device, pressing Ctrl+B on the keyboard, clicking the last device, and pressing Ctrl+B on the keyboard. Users must draw a frame round devices which are in the same network, and the devices must be adjacent to one another. Besides, input devices and output devices cannot be in the same frame. If users want to select several networks, they can press Ctrl on the keyboard, and click the networks.
The users and the last network within the range. can also select a range of networks by pressing Shift on the keyboard, clicking the first network within the range, 4-17