ISPSoft User Manual 9.2.3 Back-up/Restore Servo Parameter Right click on the “Axis” node, then click “Back-up/Restore Servo Parameter” to backup real axis settings to ISPSoft, PLC Flash or PLC SD Card, at the same time, users can also restore settings from the backup to these three locations by selecting the intended action and clicking “Start”. The following example presents backup and restore operations. Select “Back-up” on the Back-up/Restore Servo Parameter window and choose ISPSoft Project as the backup destination, then click “Start” to proceed. After completion, click “OK” in the pop up confirmation box. 9-34