Chapter 10 Ladder Diagram 10.2.8 Putting a Label If users want to use a jump instruction, they have to put a label on the network to which the execution of the program jumps. A label is put at the right side of a network number. If users want to specify a label in an instruction, they do not have to type a colon in front of the label. The steps of putting a label are as follows. (1) Click the right side of the network number at which a label will be put. (2) Users have to type a label symbol. Press Enter on the keyboard after a P device number or a label symbol is typed. The system will automatically put a colon at the right side of the label. 10-23