Chapter 18 Testing and Debugging Tools Setting the source to Time for the axes means the data of the 3D chart is from the time of the axes and the value of axes will be increased by 1 every second. of a curve. After that the created curve will be listed below the 3D chart. Click to select a curve you’d ike to edit. Set up the width and the color for the curve and then click OK on Curve Setting page to complete the creation Click to delect the selected or click … to open the curve set up page and set up again. Use the drop-down list to change the color of the selected curve and select or deselect the checkbox to show or hide the curve on the 3D chart.
Up to 10 curves can be added on one 3D chart. 18.5.4 Display a 3D Chart chart is created, make sure the motion control CPU is connected to your computer and then the 3D chart will be Follow the procedures aforementioned to download program and complete the monitoring setups. After a 3D displayed. To edit a created curve, users can use the drop-down list on the area or click to select a curve from the list . After selection, click and to edit the curve or click to delete the selected curve. 18-43