Setup computer tool Lansen Configurator Step Action Troubleshooting 1 Extract the *.zip - file ( LansenConfigurator ) to a fo The dongle was not found or recognized by your computer. Unplug and plug in • ca port within five minutes. In this ot find the correct COM AutoDetect does n • - Batery conection: Check conections on both ends of the is fu onnect the battery Use a magnet on the re(di fr eneodt connected • C ) switch (located behi • battery cable so it • break: Try moving the cable to diferent positions and check if the cable Cable is • Faulty batery: Try with another batery The repeater is not in listening mode. Try using a magnet or remove and • insert :
It is posible to conect to a repeater if it is alread • re nd Tthhee rseepreiaa tl e rn u im sb e tr o l ca lb ose el t No ot the e USB dongle. Make sure the distance is at least ) 1m • - A popup with the text “Timeout awaiting data response” is shown if the program f • Repeaitse cro rirse cotn (red LED ID lamp is blinking) o Repeater is within range o - (locate lamp is not blinking, use a magnet on the red red o If the red LED switch • -