[Public] 56268 Rev. 1.05 November 2021 AMD NVMe/SATA RAID Quick Start Guide for Windows Operating Systems 3.2 Enable RAID for 300/400/500 AMD Socket AM4-Compatible Processors Note: The steps to configure a system to RAID mentioned here are specific to AMD NDA BIOS based off the AMI BIOS . The steps for other BIOS Vendors are different. 1. Power-on the system. 2. Press ESC to enter the System BIOS setup page. 3. In the BIOS setup: a. Select the Advanced tab. b. Select CSM Configuration , then press Enter. c. Set CSM Support to Enabled , then press Enter. d. Set Boot option filter to UEFI only, then press Enter. e. Set Storage to UEFI , then press Enter. 4. In the BIOS setup: a.
Select the Advanced tab. b. Select AMD-CBS, then press Enter. c. Select FCH Common Options , then press Enter. d. Select SATA Configuration Options , then press Enter. e. Set SATA Enable to Enabled , then press Enter. f. Set SATA Mode to RAID , then press Enter. 5. In the BIOS setup: a. Select the Advanced tab. b. Select AMD-CBS, then press Enter. c. Select 300/400/500 Chipset Common Options , then press Enter. d. Select 300/400/500 Chipset SATA Configuration Options , then press Enter. e. Set SATA Mode to RAID , then press Enter. 6. In the BIOS setup: a. Select the Advanced tab. b. Select AMD-PBS , then press Enter. c. Set NVMe RAID Mode to Enabled , then press Enter. 7.
Save ( F4 ) the settings and restart the system. Chapter 3 Pre-Installation Steps 11