[Public] 56268 Rev. 1.05 November 2021 AMD NVMe/SATA RAID Quick Start Guide for Windows Operating Systems 3.4 Enable RAID for AMD Socket AM4-Compatible Processors Note: The steps to configure a system to RAID mentioned here are specific to AMD NDA BIOS based off the Insyde BIOS . The steps for other BIOS Vendors are different. 1. Press ESC to enter the System BIOS setup page. 2. Select Setup Utility , then press Enter. 3. In the BIOS setup: a. Select the Advanced tab. b. Select IDE Configuration , then press Enter. c. Set SATA Configure As to RAID , then press Enter. d. Set Force RAID Mode to Enabled , then press Enter. 4. In the BIOS setup: a. Select the Boot tab. b.
Set Boot Type to Dual or UEFI Boot Type , then press Enter. c. Set EFI Device First to Enable , then press Enter. 5. In the BIOS setup: a. Select the AMD - PBS tab. b. Set NVMe RAID Mode to Enabled , then press Enter. 6. In the BIOS setup: a. Select the AMD-CBS tab. b. Select SATA Configuration Options , then press Enter. c. Set SATA Controller to Enabled , then press Enter. d. Set SATA Mode to RAID , then press Enter. 7. In the BIOS setup: a. Select the AMD-CBS tab. b. Select Promontory Common Options , then press Enter. c. Select PT SATA Configuration Options , then press Enter. d. Set PT SATA Port Enable to Enabled , then press Enter. e. Set PT SATA Mode to RAID , then press Enter. 8.
Save ( F10 ) the settings, then restart the system. Chapter 3 Pre-Installation Steps 13