Table 3-8. Paper Handling Menu (continued) Note Items marked with an * only appear in the menu if the 2 x 500-sheet Input Tray, the 2000-sheet Input Tray, or the duplexer are installed. To see the default fuser mode for each paper type, select YES , scroll back to the Information Menu, and print a menu map. C4265-90907 Printer Control Panel Menus 107 Item Values Explanation [TYPE]=NORMAL NORMAL LOW HIGH1 HIGH2 HIGH3 This item appears when CONFIGURE FUSER MODE MENU=YES. The printer speeds are for Letter or A4.Press - VALUE + or to make your selection, and press SELECT to save the setting. NORMAL = 32 ppm. LOW = slightly lower temperature at 32 ppm.
HIGH1 = slightly higher than normal at 32 ppm. HIGH2 = slightly higher than normal at 24 ppm. This allows more time to fuse toner for special types of media (i.e. heavy, rough stock) HIGH3 = slightly hotter fusing than H1 or H2 at 16 ppm, for media needing more time in the fusing process. Most paper types are set to NORMAL by default. The exceptions are as follows: TRNSPRNCY=LOW LABELS=HIGH1 CARDSTOCK=HIGH2 ROUGH=HIGH1 Caution: If you change the fuser mode to HIGH1, HIGH2 or HIGH3, be sure to change it back to the default when you are done printing. Setting a paper type to HIGH1, HIGH2 or HIGH3 may shorten the life of the fuser or cause other failures or jams.
CONFIGURE FUSER MODE MENU=NO NO YES Default is NO. Choose YES to configure. The fuser mode can be changed only from this menu option in the control panel. Note: To see the default fuser mode for each papertype, select YES, scroll pack to the Information Menu, and print a menu map. CONFIGURE EDGE TO EDGE=NO NO YES HP LaserJet 8150 Series only. Configure the margin alignment of the tray you wish to print an edge-to-edge print job from. NO: The edge-to-edge configuration menu items are not accessible. YES: Additional edge-to-edge configuration menu items appear.