HP Digital Copier Administrator Mode Administrator Mode is a separate mode from Service Mode. This mode allows you to set defaults for copy jobs only. This mode does not set defaults for print jobs or for digitally sent jobs. To set defaults for print jobs see “HP Digital Copier Settings” on page 136. This mode is password protected so that only administrators can enter. To enter Administrator Mode type in 999#320* while the printer and copy module are turned on and ready. You will now see the Administration Menu. Press S ET C OPY D EFAULTS . You will now see the end user control panel. Set each area to the desired default state. The areas that can have defaults chosen are:
G Paper--set defaults G Reduce/Enlarge--cannot set defaults G 2-Sided/N-Up-Set--set defaults G Output/Staple--set defaults G Copy Quality--set defaults G Book Copy--cannot set defaults G Job Binding--cannot set defaults G Configuration--set defaults Make sure to press S AVE when you are finished. Press E XIT A DMIN M ODE to see the regular end-user screen. Note There is a setting in the Administrator Mode to restore the defaults to factory settings. C4265-90907 HP Digital Copier Administrator Mode 147