Adjusting Printer Input Trays Adjusting for Edge-to-Edge Printing Note Edge-to-Edge printing is available in the HP LaserJet 8150 Series only. This feature provides the user with the ability to print within approximately 2 millimeters of all edges of the page. An internal-tray calibration page allows the administrator to calibrate each tray. The calibration page can be printed from each internal tray and the top tray of an external paper- handling device. The calibration page cannot be printed from the envelope feeder. The edge- to- edge print mode is set from the printer driver or the control panel. It is most common to use the printer driver when printing individual print jobs.
When set from the control panel, the edge-to-edge feature will remain in edge- to- edge print mode until turned off from the control panel or from a print job. To print a calibration page: 1 Make sure that paper is loaded in the desired tray or trays and that the trays are properly inserted into the printer 2 Press M ENU repeatedly until PAPER HANDLING MENU appears. 3 Press I TEM repeatedly until CONFIGURE EDGE TO EDGE= NO appears. 5 Press S ELECT . 4 Press V ALUE to change the value to YES . 6 Press I TEM repeatedly until PRINT TEST PAGE TRAY= n appears. 7 Press V ALUE to choose the desired tray ( ALL , 1 , 2 , 3 , or 4 ). 8 Press S ELECT to print the calibration page.
9 Follow the instructions on the calibration page to complete the calibration process. CAUTION When using edge-to-edge printing, clean the printer every time the toner cartridge is changed. C4265-90907 Adjusting Printer Input Trays 169