L-6534VW Operation Guide Basic Operations Note: ❏ Out of the two sensors side by side, the one on the right side (b) is the eye mark sensor. a: Paper width sensor b: Eye mark sensor ❏ If you cannot see the eye mark sensor light or the eye mark on the printed surface during alignment, open the bottom front cover and check them through the observation hole for adjusting the eye mark sensor on the bottom side. a: Mirror b: Eye mark and sensor light that are reflected in mirror N When the check box for Auto Center Align is cleared and after the eye mark sensor moves, visually check the place where the position of the sensor light matches the position of the eye mark.
Then fine-tune the value of Distance from Top Edge of Substrate . O When adjusting the eye mark sensor on the bottom side, close the bottom front cover on the press. P Close the top front cover on the press. Q Press Adjust Sensor Sensitivity . Eye mark detection and sensitivity adjustment for the eye mark sensor start. 131