L-6534VW Operation Guide Basic Operations Stopping the Press in an Emergency If you sense any danger while using the press, or if the substrate becomes jammed and so on, press the EMERGENCY STOP switch to stop the press immediately while printing. There are EMERGENCY STOP switches located at four positions on the press; the main panel on the main unit, the sub panel, the corona treater, and the additional UV lamp curing unit. Operations stop when one of the switches is pressed, and an error is displayed on the touch panel. c Important:
❏ When you stop printing by using the EMERGENCY STOP switch, it may have an adverse effect on the head, or you may need to perform recovery operations such as reloading the substrate and so on. Do not press the EMERGENCY STOP switch unless there is an emergency. ❏ If it is not an emergency, press the Pause switch to pause printing. U “Pausing/Resuming Printing” on page 140 ❏ If smoke is detected, the press performs an emergency stop automatically. When an emergency stop is activated in the following statuses, the power supply is cut. 156 Press Parts Status Cover The cover can be opened. Feed substrate Immediately stops.
Release the tension from the substrate so that the substrate can be removed. Carriage unit Immediately stops. Be careful when opening the covers as the stop position of the carriage unit differs according to the circumstances when the press was stopped. Do not touch the light shield or the carriage. Emitting UV Immediately stops. Ink that has not been cured remains in the area where printing is complete. Mechanical configuration (sensor types, fans, and so on) Immediately stops.