L-6534VW Operation Guide Various Print Settings B Set the output to 2,000 W on the control panel of the corona treater. Note: When printing the white plate of reverse white printing, we recommend performing corona processing to reduce the outbreak of pinhole wrinkles. C Check that the press switch is set to the Standby position. D Perform printing from the print software, and then check that the print data for white plate was received on the touch panel. E Select the print job from the Job Management menu, and then press Print Settings . F Set the following, and then press OK . G Open the Feed Subst tab from the Substrate Settings menu.
H Set the Feeding Amount to "-(print length + Lead In) m", and then press Start feed . The value for Lead In corresponds to the value set in a preset for color plate printing. I Set the Feeding Amount to "Lead In - 5 m", and then press Start feed . The value for Lead In corresponds to the value set in a preset for color plate printing. J Set the Feeding Amount to "0.7 m", and then press Start feed . K Align the eye mark sensor with the eye mark at the point where printing starts. U “Setting Eye Marks and Eye Mark Sensor” on page 125 L Press Adjust Print Position on the Loaded Substrate tab, and then set Adjust Print Position Horizontally and Adjust Print Position Vertically to 0.
M Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing. Print the first copy, and then pause on the unwinder side workbench. N Check the print results and measure the print shift in the color and white plates, and then enter the horizontal and vertical shift values in Adjust Print Position Horizontally and Adjust Print Position Vertically as the adjustment values. O Press Print . 183 Item Set value Copies 1 Perform Eye Mark Verification Printing Select