L-6534VW Operation Guide Various Print Settings Necessary Settings for Surface Printing Preset for Printing (for Surface Printing) Lead Out is the necessary margin left before the print start position when printing on the surface. Also, Lead In is the margin after the last page when printing the white plate. Set Lead In so that you can print including the last page when printing the white plate.
Preset for Reverse Feeding (for Surface Printing) Necessary Settings for Rear Surface Printing Preset for Printing (for Rear Surface Printing) 187 Item Set value Lead In 39 m or more (at a print speed of 30 m/min) U “Setting value for Preset for Printing” on page 69 Lead Out 25 m (at a print speed of 30 m/min) U “Setting value for Preset for Printing” on page 69 Item Set value Reverse Feeding Apply Eye Mark for Reverse Feeding Use Distance from Top Edge of Substrate Apply to print data Distance from Right Edge of Print Job Apply to print data Reverse Feeding Position Adjustment 0 mm Item Set value Additional Printing Apply Eye Mark Horizontal Offset Set the distance from the right edge of the eye mark to the right edge of the print data.
See the following when setting a value of more than 500.0 mm. U “Settings when the Eye Mark Offset exceeds 500 mm” on page 169 Eye Mark Pitch Enter the print data width for surface printing Eye Mark Sensor Position Bottom Lead In 0 m Lead Out 0 m