L-6534VW Operation Guide Various Print Settings N Enter the calculated adjustment value in Reverse Feeding Position Adjustment . O Press Print . P On the screen displayed, enter the number of copies, and then press Print . Start surface printing. This completes this section. Procedure for Rear Surface Printing Follow the print procedure for surface printing. A Set additional printing for rear surface printing in a preset suitable to the type of substrate loaded, and set it as the default preset.
U “Necessary Settings for Rear Surface Printing” on page 187 U “Creating and Editing Print Info.” on page 89 U “Creating and Editing Preset for Printing” on page 91 B Check that the press switch is set to the Standby position. C Perform printing from the print software, and then check that the rear surface print data for this print job was received on the touch panel. D Select the print job from the Job Management menu, and then press Print Settings . E Set the following, and then press OK . F Remove the unwinder side substrate. U “Replacing the Unwinder Side Substrate” on page 99 steps 1 to 10 190 Item Set value Copies 1 Perform Eye Mark Verification Printing Select