L-6534VW Operation Guide Various Print Settings Printing on the Substrate Including a Splice When you print on a substrate including any splice and if you use the splice detection function, approximately 9 m (at a print speed of 30 m/min) of the spliced section and margin is fed and printing restarts automatically. Note that the splice detection is available for the substrate color of White, Black, Yellow, Light blue, Brownish Color, Clear, and Metallic. When you use any substrate color other than the above-described colors, see the next section and switch the connection to a sensor for detecting the reverse printable surface.
If any splice is detected, approximately 9 m (at a print speed of 30 m/min) of the spliced section and margin is fed and printing restarts automatically. For printing on splices, turn off the splice detection function. In this case, make sure that the overall thickness of the joint including the tape overlaps or wrinkles is 0.135 mm or less. Turn on or off the splice detection function in the Maintenance menu, Press Settings - Print Operation Settings - Operation when Substrate Joint Detected . U “Print Operation Settings” on page 41 For specifications of the splicing tape and the spliced section, see the following.
U “Substrate splicing specifications” on page 66 Changing the detection side for the splice detection function A Open the top front cover and the bottom front cover on the press. B Open the safety cover for the sensor amplifier. 214