INTRODUCTION IN-13 INSTALLATION PRE-WELDING MEASUREMENTS Always take measurements before installing underbody or engine com- ponents to insure correct assembly. After installation, confirm proper fit. WELDING PRECAUTIONS 1. The number of welding spots should be as follows. Spot weld: 1.3 x No. of manufacturer’s spots. Plug weld: More than No. of manufacturer’s plugs. POST WELDING REFINISHING 1. Always check the welded spots to insure they are secure. 2. When smoothing out the weld spots with a disc grind- er, be careful not to grind off too much as this would weaken the weld. WRONG WRONG OKAY 2. Plug welding should be done with a MIG (Metal Inert Gas) welder.
Do not gas weld or braze panes at areas other than specified. Safety Glass Body Measurement Diagrams SPOT WELD LOCATIONS Try to avoid welding over previous spots. New Spot Locations Old Spot Locations SPOT WELDING PRECAUTIONS 1. The shape of the welding tip point has an effect on the strength of the weld. 2. Always insure that the seams and welding tip are free of paint. Tip Cutter