INTRODUCTION IN-15 Mandrel RIVET REMOVAL AND INSTALLATION PARTS NAME AND VARIETY OF RIVET Flange φ X mm Rivet Size RIVET REMOVAL 1.
SELECTION OF CUTTING TOOL Aluminum-Rivet Steel-Rivet Waterproof-Rivet T-Rivet External Appearance Before installation After installation Outer Inner Before installation After installation Outer Inner Before installation After installation Waterproof Seal Outer Inner Before installation After installation Mandrel Outer Inner Charac- teristics Small nonwaterproof rivet No magnetic adherence Small nonwaterproof rivet Magnetic adherence Small waterproof rivet Waterproof seal Large waterproof rivet Mandrel sticks out after installation Cutting tool Note Aluminum-Rivet Steel-Rivet T-Rivet with φ6.4 mm Drill blade Rivet size Blade size φ4 mm φ4 mm φ4.8 mm φ5 mm φ6.4 mm φ6.5 mm Cutting can be done with drill blade or rivet cutter for an aluminum-rivet with φ4.8 mm.
When a rivet cutter is used for an aluminum-rivet (except φ4.8 mm), a steel-rivet, or a Trivet with φ6.4 mm, it is possible that the drill will spin abnor- mally damaging the rivet hole and breaking the rivet cutter. Waterproof special-Rivet with φ4.0 mm Drill blade with φ4.0 mm Aluminum-Rivet with φ4.8 mm Waterproof-Rivet with φ4.8 mm or φ6.0 mm Rivet Cutter (P/N 09060-60350) When a ordinary cutter is used for a waterproof-rivet with φ4.8 mm or φ6.0 mm, the rivet can not be cut as it spins with the cutter. Rivet size Blade size φ4 mm φ4 mm φ4.8 mm φ5 mm φ6.4 mm φ6.5 mm