Last Modified: 6-7-2017 6.8:8.0.40 Doc ID: RM0000019ZA000X agn Model Year Start: 2006 Model: Land Cruiser Prod Date Range: [05/2005 - ] Title: BRAKE: HYDRAULIC BRAKE BOOSTER: INSTALLATION; 2006 MY Land Cruiser [05/2005 - ] INSTALLATION 1. INSTALL HYDRAULIC BRAKE BOOSTER ASSEMBLY (a) Install a new gasket and the booster with the 4 nuts. Torque: 15 N·m {155 kgf·cm, 11ft·lbf} (b) Install the clevis pin with the clip. (c) Using SST, connect the 4 brake lines. SST: 09023-00101 Torque: 15 N·m {155 kgf·cm, 11ft·lbf} without SST 14 N·m {143 kgf·cm, 10ft·lbf} with SST HINT: Use a torque wrench with a fulcrum length of 30 cm (11.81 in.). (d) Connect the 5 connectors. 2.
INSTALL CHARCOAL CANISTER SUB-ASSEMBLY 3. INSTALL SKID CONTROL ECU ASSEMBLY (a) Install the skid control ECU with the 2 nuts. Torque: 5.0 N·m {51 kgf·cm, 44in·lbf} 4. INSTALL NO. 2 HEATER TO REGISTER DUCT 5. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER LH 6. INSTALL NO. 1 INSTRUMENT PANEL LOWER PANEL 7. INSTALL COWL SIDE TRIM BOARD LH 8. INSTALL FRONT DOOR SCUFF PLATE LH 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 10. FILL RESERVOIR WITH BRAKE FLUID 11. BLEED AIR FROM HYDRAULIC BRAKE BOOSTER (a) Procedures when using intelligent tester . (b) Procedures when using ABS actuator checker . 12. BLEED AIR FROM BRAKE LINE 13. CHECK BRAKE FLUID LEVEL IN RESERVOIR cardi