Control) LOGICAL ADDRESS DTC Transmission DIAGNOSIS ITEM Registration Request command is output from sub- DIAGNOSIS CONTENT master component. COUNTERMEASURE AND INSPECTED PARTS agn 01 (Communication Control) E4 Multiple Frame Abort Multiple frame transmission is aborted. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 01 (Communication Control) 22 RAM Error Abnormal condition of RAM is detected. Replace disc player changer. (f) Physical address:
250 (DVD Auto Changer) (Sub AVC-LAN) LOGICAL ADDRESS DTC DIAGNOSIS ITEM DIAGNOSIS CONTENT COUNTERMEASURE AND INSPECTED PARTS 01 (Communication Control) D6 *1 Absence of Master Component in which this code is recorded has been disconnected from system with ignition in ACC / ON. Or, when this code was recorded, radio receiver assembly was disconnected. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. Check harness for power supply of disc player changer. Check harness for communication system of disc player changer.
01 *6 (Communication Control) D7 Connection Check Error Component in which this code is recorded has been disconnected from system after engine start. Or, when this code was recorded, radio receiver assembly was disconnected. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. Check harness for power supply of disc player changer. Check harness for communication system of disc player changer. 01 (Communication Control) DC *2 Transmission Error Transmission to component shown by auxiliary code has been failed.
(This mode does not necessarily mean actual failure.) If same auxiliary code is recorded in other component(s), check harness for power supply and communication system of components shown by sub code. 01 (Communication Control) DD *3 Master Reset (Momentary Interruption) After engine is started, radio received assembly assembly was disconnected from system. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. If error occurs frequently, replace radio receiver assembly. 01 (Communication Control) DF *4 Master Error Due to defective of component with a display, master function is switched to audio equipment.
Error occurs in communication between sub-master (audio) and master component. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. Check harness for communication system between radio receiver assembly and sub- master component. 01 (Communication Control) E0 *1 Registration Completion Instruction Error "Registration Completion instruction" command from radio receiver assembly cannot be received. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists.
01 (Communication Control) E2 ON / OFF Instruction Parameter Error Error is detected in ON / OFF control command from radio receiver assembly. Replace radio receiver assembly. 01 (Communication Control) E3 Registration Request Transmission Registration Request command is output from slave assembly. By reception of connection check instruction, Registration Request command is output from sub- master component. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 45 (DVD) 42 No Disk Readout Disk cannot be read. Inspect disc. cardi