TESTER DISPLAY PARKING MEASUREMENT PNP switch ITEM/RANGE status/ Shift lever is: NORMAL CONDITION On P: ON actual position, adjustment of PNP switch or shift cable may be DIAGNOSTIC NOTE incorrect agn ON or OFF Not on P: OFF HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 NEUTRAL PNP switch status/ ON or OFF Shift lever is: On N: ON Not on N: OFF When shift lever position displayed on intelligent tester differs from actual position, adjustment of PNP switch or shift cable may be incorrect HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 DRIVE PNP switch status/ ON or OFF Shift lever is: On D: ON Not on D:
OFF When shift lever position displayed on intelligent tester differs from actual position, adjustment of PNP switch or shift cable may be incorrect HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 4TH/DRIVE PNP switch status/ ON or OFF Shift lever is: On 4: ON Not on 4: OFF When shift lever position displayed on intelligent tester differs from actual position, adjustment of PNP switch or shift cable may be incorrect HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 3RD PNP switch status/ ON or OFF Shift lever is: On 3: ON Not on 3:
OFF When shift lever position displayed on intelligent tester differs from actual position, adjustment of PNP switch or shift cable may be incorrect HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 2ND PNP switch status/ ON or OFF Shift lever is: On 2: ON Not on 2: OFF When shift lever position displayed on intelligent tester differs from actual position, adjustment of PNP switch or shift cable may be incorrect HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 LOW PNP switch status/ ON or OFF Shift lever is: On L: ON Not on L:
OFF When shift lever position displayed on intelligent tester differs from actual position, adjustment of PNP switch or shift cable may be incorrect HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 PATTERN PWR/M Pattern switch (PWR) status/ ON or OFF Pattern switch (PWR) is: Pushed: ON Not pushed: OFF - SNOW SW Pattern switch (ECT 2nd) status/ ON or OFF Ignition switch is: ON: OFF ↓ Pattern switch (ECT 2nd) is: Pushed: ON ↓ Pattern switch (ECT 2nd) is: Pushed: OFF - A/T OIL TEMP1 ATF temperature sensor No. 1 value/ Min.: -40°C (- 40°F) Max.: 215°C After stall test:
Approximately 80°C (176°F) Equal to ambient temperature while engine is cold If value is -40°C (-40°F) or 215°C (419°F), ATF temperature sensor No. 1 circuit is opened or short circuited cardi