cardiagn.com NOTICE: Do not tear the service hole cover. 22. REMOVE BACK DOOR KEY CYLINDER (a) Disconnect the connector. (b) Remove the 2 bolts and key cylinder. Torque: 5.0 N·m {51 kgf·cm, 44in·lbf} 23. REMOVE BACK DOOR LOCK (a) Disconnect the control cable from the clamp. (b) Using a "torx" wrench, remove the 3 screws and back door lock. "Torx" wrench: T30 (Part No. 09042-00010 or locally manufactured tool) Torque: 5.0 N·m {51 kgf·cm, 44in·lbf} HINT: At the time of reassembly, please refer to the following item. Apply MP grease to the rotating parts of the door lock. (c) Employ the same manner described above to the other side. 24. REMOVE REAR LIGHT ASSEMBLY (a) Disconnect the connector.
(b) Remove the 2 nuts. (c) Using a screwdriver, remove the rear light. HINT: Tape the screwdriver tip before use. (d) Employ the same manner described above to the other side. 25. REMOVE TAIL GATE STAY SUB-ASSEMBLY (a) Using a torx wrench, remove the 2 screws and tail gate stay. "Torx" wrench: T 30 (Part No. 09042-00010 or locally manufactured tool) Torque: 18.5 N·m {189 kgf·cm, 14ft·lbf} (b) Employ the same manner described above to the other side.