Appendix B Appendix B Ethernet Communication Ethernet Communication Port in DVP10MC11T: DVP10MC11T provides an Ethernet port possessed by motion control module supporting Modbus TCP protocol. CANopen Builder software could be used to download CANopen motion control network configuration, motion program, G codes and monitor devices via this port. DVP10MC11T can only serve as slave in Ethernet network and also accept the access from 4 masters. Besides, this port supports auto jumper function as well. When connected to computer or switchboard, DVP10MC11T does not need to be handled in jumper specially.
LED of Ethernet port is used to indicate the current connection state of Ethernet so that user could check conveniently. Pin Definition and LED Indicator Instruction Pin Definition of Ethernet Communication Port in DVP10MC11T: LED Indicator of Ethernet Communication Port in DVP10MC11T DVP10MC11T possesses two Ethernet LED indicators like orange light and green light. Green light is to indicate the communication state of Ethernet network; orange light is to indicate communication rate of Ethernet network. DVP-MC operating manual B-1 Terminal No.
Definition Explanation RJ -45 figure 1 Tx+ Positive pole for transmitting data 2 Tx- Negative pole for transmitting data 3 Rx+ Positive pole for receiving data 4 -- N/C 5 -- N/C 6 Rx- Negative pole for receiving data 7 -- N/C 8 -- N/C LED indicator State Indication Orange light On The communication rate of Ethernet: 100Mbps。 Off The communication rate of Ethernet is 10Mbps or DVP10MC11TT is not connected to Ethernet. Green light Green light flash The Ethernet port of DVP10MC11T is sending or receiving data. Off The Ethernet port of DVP10MC11T is not sending or receiving data.