cardiagn.com Last Modified: 4-30-2014 6.6 A Doc ID: RM000001AE4001X Model Year: 2006 Model: LX470 Prod Date Range: [05/2005 - ] Title: SUSPENSION: FRONT UPPER SUSPENSION ARM: REMOVAL; 2006 MY LX470 [05/2005 - ] REMOVAL 1. REMOVE FRONT WHEEL Torque: 131 N·m {1,340 kgf·cm, 97ft·lbf} 2. REMOVE FRONT FENDER APRON SUB-ASSEMBLY 3. DISCONNECT FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (a) Place matchmarks on the height control sensor link and upper suspension arm. (b) Remove the nut and disconnect the height control sensor link. Torque: 5.6 N·m {57 kgf·cm, 49in·lbf} 4. DISCONNECT SKID CONTROL SENSOR WIRE (a) Remove the 2 bolts and disconnect the sensor wire harness. Torque:
13 N·m {130 kgf·cm, 10ft·lbf} 5. DISCONNECT STEERING KNUCKLE (a) Support the lower suspension arm with a jack. (b) Remove the cotter pin and nut. Torque: 110 N·m {1,125 kgf·cm, 81ft·lbf} HINT: At the time of installation, if the holes for the cotter pin are not aligned, tighten the nut further up to 60° (c) Using SST, disconnect the steering knuckle from the upper suspension arm. SST: 09628-62011 6. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY (a) Place matchmarks on the front and rear No. 2 adjusting cams and body. (b) Remove the 2 nuts, No. 1 and No. 2 camber adjust cams and upper suspension arm. Torque: 98 N·m {1,000 kgf·cm, 72ft·lbf} HINT:
At the time of installation, after stabilizing the suspension, torque the nuts.