Last Modified: 7-3-2017 6.8:8.0.40 Doc ID: RM000000W7E03VX agn Model Year Start: 2007 Model: LX470 Prod Date Range: [08/2006 - ] Title: A750F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: DATA LIST / ACTIVE TEST; 2007 MY LX470 [08/2006 - ] DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the intelligent tester's DATA LIST allows switch, sensor, actuator, and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time. NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Warm up the engine. (b) Turn the ignition switch OFF. (c) Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3. (d) Turn the ignition switch ON. (e) Turn the intelligent tester ON. (f) Enter the following menus: DIAGNOSIS / OBD/MOBD / ECT / DATA LIST. (g) Follow the instructions on the tester and read the DATA LIST. TESTER DISPLAY MEASUREMENT ITEM/RANGE NORMAL CONDITION DIAGNOSTIC NOTE SPD(SP2) Output shaft speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) Vehicle stopped: 0 km/h (0 mph) (output shaft speed is equal to vehicle speed) - SPD(NT) Input shaft speed/ Min.: 0 rpm Max.: 12,750 rpm Lock-up is ON (after warming up engine):
Input turbine speed (NT) is equal to engine speed OFF (idling with shift lever on N): Input turbine speed (NT) is nearly equal to engine speed Data is displayed in increments of 50 rpm PNP SW [NSW] PNP switch status/ ON or OFF Shift lever is: On P and N: ON Not on P and N: OFF When shift lever position displayed on intelligent tester differs from actual position, adjustment of PNP switch or shift cable may be incorrect HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 STOP LIGHT SW Stop light switch status/ ON or OFF Brake pedal is Depressed: ON Released: OFF - SHIFT ECM gear shift command/ 1st, 2nd, 3rd, 4th or 5th Shift lever position is On D:
1st, 2nd, 3rd, 4th or 5th On 4: 1st, 2nd, 3rd or 4th On 3: 1st, 2nd or 3rd On 2: 1st or 2nd On L: 1st - REVERSE PNP switch status/ ON or OFF Shift lever is: On R: ON Not on R: OFF When shift lever position displayed on intelligent tester differs from actual position, adjustment of PNP switch or shift cable may be incorrect HINT: When failure still occurs even after adjusting these parts, refer to DTC P0705 When shift lever position displayed on intelligent tester differs from cardi