Introduction 1.3. About Roles referred to in this Guide: Through the document the header will indicate the role you are undertaking. Roles will be marked as follows: SiteManager Installer This role covers the following tasks: Physically Install SiteManagers (often done by the service engineer or the customer). Configure network settings (primarily initial GateManager access). Optionally configure device agents on the SiteManager, if not done by the LinkManager user. GateManager BASIC administrator This role covers the following tasks: Creating and administering LinkManager user accounts. LinkManager User This role is held by the PLC programmer or service engineer:
Connect remotely to equipment for servicing/programming the equipment. Optionally configure the SiteManager and device agents on the SiteManager, if not done by the SiteManager In- staller role. 1.4. Illustration of Role locations The typical setup of the relative to the Internet would be like this: GateManager Server LinkManager User SiteManager Installer GateManager Administrator Secomea GateManager5 BASIC Guide Page 4 of 26