IN CASE OF EMERGENCY Jump starting With the ignition switched off and the hood opened: Jump starting VESPER 1 Remove the engine compartment cover and the battery fuse box cover , please refer to the (p. ) . 2Connect the red jumper cable to the positive terminal (2) on the booster battery. 3Connect the other end of the red jumper cable to the positive terminal (4) on the discharged battery. 4Connect the black jumper cable to the negative terminal (1) on the booster battery. 5Connect the other end of the black jumper cable to the specified ground point (3) on the vehicle's body.
Make sure the jumper cable and charging terminals are fixed securely so that there are no sparks during the starting attempt, causing electrical components to malfunction. Caution! With the battery lid and battery fuse box cover removed Warning! ■ Do not connect the jumper cable to the fuel system or any parts that move. ■ Do not touch areas of the engine bay which might be hot. ■ Do not use a booster battery of more than 12 V. ■ Connect the jumper cables carefully to avoid short circuits with other components in the engine compartment. ■ Never allow the two vehicles to be in contact during jump starting.
■ Do not connect the negative cable directly to the negative terminal of the discharged battery. 6Start the engine in the vehicle with the charged battery. Without depressing the brake pedal of the vehicle with the discharged battery, the vehicle enters the ignition mode I by pressing the ignition switch, and then the vehicle enters the ignition mode II by pressing the ignition switch again. 233