MAINTENANCE AND SERVICE the inflation label located on the B-pillar driver's side and in the technical data section . Tire care Warning! VESPER Correct inflation pressures and good habits help increase the service life of your tires. ■ Under-inflation or over-inflation may adversely affect tire life and vehicle handling, resulting in a loss of control of the vehicle. ■ Please install the wheels/tires certified by Lynk & Co to meet stringent stability and handling requirements. Any damage caused by installation of unapproved wheel/tire will not be covered by your new vehicle warranty.
Lynk & Co assumes no responsibility for property loss or personal injury that may result from such installations. ■ Check the tire pressures regularly (at least once a month). ■ Check the tire regularly for damage (such as cuts, cracks or pits) and irregularly for abnormal wear. ■ Keep grease, oil and fuel off the tires. ■ Drive at moderate speed after tire renewal. ■ Avoid fast cornering and hard acceleration. ■ When removed, store the wheels or tires in a cool, dry, dark place. Never store them in close proximity to solvents, gasoline and oils. Warning! If the tire pressure drops repeatedly, the wheel rim, valve or tire may be damaged. Insufficient tire pressure can lead to flat tire.
There is a danger of accidents, so you should: Note! The normal service life of tire is 3 years or 40,000 km. If it exceeds the normal service life, it needs to be tested and confirmed by professional personnel. Tires age and decompose, even if they are hardly ever or never used. Their functions may therefore be affected. This applies to all tires that are stored for future use. ■ Check the tire for foreign matters. ■ Check the tire, if there is pressure loss or valve leakage, please contact Lynk & Co Center for help. Caution! After inflating the tires, always reinstall the valve cap to help avoid damage to the valve from dirt and gravel. Only use plastic valve caps instead of metallic caps.
Metal caps could corrode and become difficult to remove. Wheel dynamic balance The dynamic balance is tested and approved before the vehicle is delivered from the factory. As you drive, many factors may affect or cause the wheel imbalance. Wheel imbalance can cause excessive wear of the steering system, the suspension and the tires. If abnormal tire wear or vehicle deviation is found, wheel alignment should be checked. If the vehicle bumps while driving on 264