HYBRID Both LED flashing in red alternatively - normal communcation. High voltage battery charging operation VESPER Charging cover location Before the high voltage battery can be charged, some preparations need to be made. Output LED flashing in green and input LED in blue - failure to ground. 1 Confirm that the vehicle is out of flame. 2Unlock the vehicle via the unlock button on the remote control key , please refer to the (p. ) or unlock the vehicle with the keyless entry , please refer to the (p. ) system. 3Open the charging cover, remove the protective cap for the charging socket. Both LED in red - power failure. Caution!
■ When the light is red, please contact Lynk & Co Center for help. ■ Clean the charging cable with a clean cloth, moistened with water or a mild detergent. Do not use chemicals or solvents. Do not immerse the charging cable in water. ■ Never unplug the charging cable from the 220 V AC socket while charging is in progress - there is then a risk of damaging the 220 V AC socket. Always stop charging first before unplugging the charging cable from the car's charging input socket and then from the 220 V AC socket.
■ When the on-board charging equipment is used for charging, plug in the 3-pin charging connector first and then the charging gun; after charging, pull out the charging gun first and then the 3-pin charging connector. Press the button on the charging gun when inserting or removing the gun. Charging outlet Charging with the on-board charging equipment Use the charging cable between the vehicle and an electrical socket to charge the vehicle ’ s high voltage battery. Make sure that all preparations for charging are followed. 48