Volume 3 of 3 - CAB AREA COMPONENT LOCATION Machine locations are repeated for components located close together. A = Located inside of cab, operator's platform B = Located inside of right console.
G = Located under operator's platform D = Located inside cab at rear Component Schematic Location Machine Location Component Schematic Location Machine Location Alarm- Action C-1 A Relay- Nuetral Start D-9 D Connector- Et Conn B-6 B Relay- Priming Pump (atch) D-11 D Control- Monitor D-1 44 Relay- Qc Hyd Lock 1 (atch) B-12 D Control- Switch Panel C-2 B Relay- Qc Hyd Lock 2 (atch) B-12 D Control- Wiper B-1 A Relay- Qc Hyd Lock On (atch) C-12 D Converter- Radio A-9 B Relay- Qc Hyd Lock Priority (atch) C-12 D Diode- Lamp F-9 D Relay- Smart Boom Down (atch) E-11 D Diode- Main Relay A-10 D Relay- Smart Boom Up (atch) E-11 D Fuse Block C-8, C-11 D Relay- Travel Alarm D-9 D Ground- Cab 1 B-4 B Resistor- Backup E-8 D Ground- Cab 2 C-7 B Resistor- Can 1 B-2 B Ground- Cab 3 E-3 B Resistor- Can 2 B-6 B Lamp- Cab Lh (atch) F-1 19 Switch- 2nd Filter B-3 B Lamp- Cab Rh (atch) F-1 19 Switch- Beacon (atch) A-6 D Lamp- Caution (for Crane)(atch) B-3 B Switch- Fine Swing Cont (atch) A-3 D Meter- Service C-1 A Switch- Fuel Filter B-3 B Outlet- 12v-7a A (atch) C-6 B Switch- Over Load Warning (atch) A-5 D Outlet- 12v-7a B (atch) C-7 B Switch- Radio Mute (atch) A-4 D Relay- Beacon (atch) D-9 D Switch- Rocker (option) B-3 B Relay- Boom Float Disable (atch) E-11 D Switch- Seat Heater (atch) A-6 D Relay- Boom Lamp E-9 D Switch- Smart Boom Select (atch) A-5 D Relay- Cab Lamp E-9 D Switch- Stg (option) B-3 B Relay- Chasis Lamp E-9 D Switch- Under Window Limit E-1 A Relay- Ether (atch) C-9 D Switch- Universal Qc (atch) A-2 B Relay- Horn E-9 D Switch- Upper Window Limit E-1 19 Relay- Main A-10 D Timer- Lamp Delay (atch) B-11 D