Nov.2002 fig.test2_70 fig.usbupdate1_70 4. Hold down the [SHIFT] button, and press the part buttons (see figure below) in the order of [1] -> [7] -> [8] -> [9]. 7. Press the [ENTER] button. The LCD display will show “Initializing....,” and then the following. part.eps * If you want to cancel the update procedure, press the [EXIT] button before you press the [ENTER] button. (The procedure cannot be cancelled after this step.) fig.usbupdate2_70 The MC-909 Menu screen will appear, and the LCD display will show the following. fig.test3_70 At this time, “[USB STATUS]” indicates the state of the USB connection. [USB STATUS] Disconnected. The computer is not connected. [USB STATUS] Connected.
The computer is connected. [USB STATUS] Receiving. Data is being received from the computer. 8. Power-on your computer. 9. Use a USB cable to connect your computer and the MC-909. (The MC-909 will appear on your computer as a removable disk drive.) Make sure that the LCD display of the MC-909 indicates “[USB STATUS] connected..” 5. Press the [F6] button. The [Service Utility] screen will appear, and the LCD display will show the following. 10. Insert the UPDATE CD-ROM (#17041222) into your computer, and navigate to the “USB” folder within the CD-ROM. fig.serviceutil_70 11. Copy the entire “Roland” folder (located within “USB”) to the MC-909 (removable disk).
The MC-909 will receive the data from the computer. Make sure that the MC-909’s LCD display shows “[USB STATUS] Receiving..” 12. When the MC-909’s LCD display changes to “[USB STATUS] Connected.,” copying has been completed. 13. On your computer, use the device eject button displayed in the taskbar at the lower right of the screen to defeat the connection with the MC-909. 14. Disconnect the USB cable. This completes the update procedure. 15. Power-on the MC-909 once again, and execute Test mode. Cautions when updating via USB 6. Press the [F6] button. The [Program Update Mode (USB)] screen will appear, and the LCD display will show the following.
• Do not power-off the MC-909 after performing step 7. If the power is turned off, the program will be lost. If this occurs, the only possible action will be to update via SmartMedia. • You must restart your computer before you begin the update procedure. 22