Routine Maintenance Vacuum-Mop Sensors Battery Use a sof cloth to clean all sensors in the vacuum-mop, including: · The four cliff sensors on the botom. · The infrared deceleration sensor on the front. · The charging contacts on the botom. · The movement sensor on the botom. The vacuum-mop contains a high-performance lithium-ion batery pack. Please ensure that it remains well-charged during daily use to maintain optimal batery performance. Note: If the vacuum-mop is not used for an extended period, turn it off and put it away. To prevent damage from over-discharging, the vacuum-mop should be recharged at least once every three months.
Cliff Sensor Charging Dock Clean the contacts of the charging dock with a sof cloth. Charging Contacts Movement Sensor Updating the Firmware You can update the firmware via the app. Before updating, make sure the vacuum-mop is on the charging dock and has at least 15% batery lef. Infrared Deceleration Sensor The power indicator of the vacuum-mop will blink quickly between white and orange alternately while its firmware is being updated. System Restarting If the vacuum-mop stops responding or cannot be turned off, press and hold down the buton for 6 seconds to forcefully turn it off. Then press and hold the buton for 3 seconds to turn the vacuum-mop on. 15