1. Products Covered Qualified Personnel The manual applies to devices of ELC and EXM series and PR series. Our full range of xLogic Micro PLC’s. Only persons qualified to correct electrical and safety Product Safety standards and regulations at the time of use should be allowed to install, commission and operate this equipment. This manual contains notices you have to observe to ensure your personal safety, as well as to prevent damage to The device/system may only be set up and used in property. The notices referring to your personal safety are conjunction with this documentation.
Commissioning and highlighted in the manual by a safety alert symbol; notices referring to property damage only, have no safety alert operation of a device/system may only be performed by qualified personnel. Within the context of the safety notices symbol. The notices shown below are graded according to in this documentation qualified persons are defined as the degree of danger. persons who are authorized to commission, ground and label devices, systems and circuits in accordance with Table 1 - Safety Warnings established safety practices and standards. Please read the complete operating instructions before installation and commissioning.
Rievtech or its distributors does not accept any liability for possible damage to persons, buildings or machines, which occur due to incorrect use or from not following this manual. Trademarks All names identified by xLogic are registered trademarks of the Rievtech. The remaining trademarks in this publication may be trademarks whose use by third parties for their own purposes could violate the rights of the owner. Copyright Rievtech 2015 all rights reserved The distribution and duplication of this document or the utilization and transmission of its contents are not permitted without express written permission. Offenders NOTICE : will be liable for damages.
All rights, including rights If more than one warning is present, then the created by patent grant or registration of a utility model or design, are reserved. warning with the highest degree of danger shall be used. Disclaim of Liability We have reviewed the contents of this publication to ensure consistency with the hardware and software described. Since variance cannot be precluded entirely, we Symbol Hazard Description Indicates that death, severe personal injury or damage to assets will result if proper precautions are not taken. Indicates that death, severe personal injury or damage to assets may result if proper precautions are not taken.
Indicates personal injury or damage to assets can result if proper precautions are not taken. Indicates that an unintended result or situation may occur if the corresponding notice is not taken.