2. Remove these additional assemblies: • Floppy drive or other plug-in module (see page 2-4). • Hard drive (see page 2-5). • Display assembly (see page 2-9). • Keyboard (see page 2-20). 3. Remove the heatsink by doing the following: • Remove the three recessed screws from the heatsink. Note: Do not remove the two middle screws from the heatsink. They hold a permanent part of the assembly. • Lift the front edge of the heatsink slightly and slide it toward the front of the computer until the four tabs along the back edge are free from the case. • Lift the right end of the heatsink and unplug the fan cable from the motherboard. Do not remove these two screws.
depends on the CPU type Figure 2-17. Removing the Heatsink 2-22 Removal and Replacement HP OmniBook 2100/3000/3100 ludes fan/cable), he CPU type e ews. an cable onnector and spacer), ype Screw, M2×5mm Note: Smaller diameter Speaker cable