Troubleshooting Solving Problems Display Problems If the OmniBook is on, but the screen is blank • Press the space bar to see if the computer is in Standby mode. • Press Fn+F1 or Fn+F2 to adjust the display. • Press Fn+F5 in case the internal display was disabled. (Do this three times to return to the state you started from.) • If the OmniBook is cold, allow it to warm up. If the screen is difficult to read • Check whether the display resolution is set to its default setting, 1024 Ч 768 (XGA) or 800 Ч 600 (SVGA). Check this in Start, Settings, Control Panel, Display, Settings. • Check brightness (Fn+F2 to increase brightness). 7-6