Making Connections Using OmniBook Plug-In Modules To insert or eject a Zip disk C A U T I O N Do not remove a Zip disk while the OmniBook is actively reading or writing data. Wait until the Zip drive is done. Otherwise, the OmniBook could stop responding and you could lose data. • Always turn on power to the OmniBook before inserting a Zip disk. • To insert the Zip disk, hold the disk with its face up, then gently slide it into the Zip drive. • To remove the Zip disk, press the eject button on the front of the Zip drive. Do not use force. It takes a few seconds to eject the disk and the green busy light blinks during this process.
• The Zip drive automatically ejects the disk when you shut down your OmniBook. • Store all Zip disks in their protective cases when not in use. If the Zip drive has no power and you need to remove a disk from it, carefully push a straightened paper clip into the emergency eject hole located on the eject button. C A U T I O N Use the manual disk eject procedure only when OmniBook power is off. Do not try to forcibly remove a Zip disk from the drive. If the disk does not eject immediately, repeat the manual disk eject procedure. 4-7