Removing the Display Assembly (HP Authorized Service Providers Only) Required Equipment Removal Procedure • Small Phillips screwdriver. 1. Unplug the ac adapter, if present, and remove the battery. 2. Remove these additional assemblies: • Keyboard (page 2-8). • Heatsink and right hinge cover (page 2-9). 3. Open the display fully. 4. Remove the left hinge cover by pressing in and lifting the front edge. Hint In the next step, unplug the connector before removing the grounding screw. Otherwise, you may unseat the LVDS PCA. 5. Unplug the display cable from the LVDS PCA, then remove the screw holding the grounding strap. 6.
Remove the four screws from the hinges and lift off the display assembly. Figure 2-7. Removing the Display Assembly HP OmniBook 7100 Removal and Replacement 2-11 Sc rew, M2.5×6mm Screw, M2.5×4